Schematic and Pcb does not load anymore

[Flux]

I wonder if there is an error log that reports the start up of the program and any errors encountered?

[mariusl]

Something I noticed after the new installation is that the software remembered the recent files. This means that there is still something somewhere that I did not delete. I did follow the full instruction though.
I must also mention that I did install the Beta version sometime last year but I deleted that from the system.

[Serg]

I wonder if there is an error log that reports the start up of the program and any errors encountered?

The program has internal logs (messages) that display warnings and errors during operation. However, there is no consolidated error log.

[Serg]

Something I noticed after the new installation is that the software remembered the recent files. This means that there is still something somewhere that I did not delete. I did follow the full instruction though.
I must also mention that I did install the Beta version sometime last year but I deleted that from the system.

The data about the most recently opened files is stored in the registry editor.
For example, for the schematic editor, this list is located here:
`Computer\HKEY_CURRENT_USER\SOFTWARE\Novarm\DipTrace\Schematic\Files`

[mariusl]

The data about the most recently opened files is stored in the registry editor.
For example, for the schematic editor, this list is located here:
`Computer\HKEY_CURRENT_USER\SOFTWARE\Novarm\DipTrace\Schematic\Files`

I made very sure that I delete that entry.

Why would the windows launcher link not work. I have to load the programs from the explorer.

[Serg]

Antivirus or security software may block the launcher or executables. If possible, temporarily disable the antivirus or add the DipTrace executables to the exception list, then try launching the application again. Try running it as Administrator. Make sure that the installation path does not contain any non-standard characters.