How to create a hole in a footprint

[newbadboy]

So im trying to create a 0.3mm hole in the footprint thermalpad area. The hole shall be only in the copperplane, not a real hole thru the pcb. As for now i have managed to only create it as a thru hole.

Any tips on how to achive the correct footprint hole?

hole.png (25.08 KiB) Viewed 12825 times

dataa.png (135.21 KiB) Viewed 12825 times

[Serg]

In the PCB Layout, you can place a via instead of a pad. Before doing this, go to the main menu Route → Via Styles and create new via style with the configuration you need.
By the way, in the Pattern Editor, to create a pad of this shape you can first draw a polygonal figure and then use the “Convert to Pad” command from the context menu.

[newbadboy]

OK ill try with a via instead. Thx

The footprint above is created by me and i used the polygonal .

It was only the correct hole i didn't found out on how to create!

[newbadboy]

I did like this. For me it looks ok but when looking at the 3d view it look lika there is o hole into the epoxy but not thur the whole pcb

via_hole.png (36.36 KiB) Viewed 12789 times

3d2.png (16.89 KiB) Viewed 12789 times

3d1.png (51.59 KiB) Viewed 12789 times