I had to create a pattern for Sullins NPPN101BFLC-RC SMD 10 pin 2mm pitch connector, the Zig-Zag style seemed to work but the pad spacing is half of what was needed.
Zig-Zag pattern issues 3.x~4.x
Zig-Zag pattern issues 3.x~4.x
- Attachments
-
- The results after 'flipping' and doubling the pitch
- zz1.jpg (46.55 KiB) Viewed 273 times
Re: Zig-Zag pattern issues 3.x~4.x
The Pattern Template tool's Pad Spacing setting refers to the pads that exist on the same line. It looks like your pattern should be vertically flipped for the BFLC.
Tom
Re: Zig-Zag pattern issues 3.x~4.x
I finally finished the part, had to draw the 3D image since for some reason there is not a SMD HDRF 2mm X 10 position image anywhere I could find. The vendor provided an image of his product, Cellular modem: