Hi Guys,
I am trying to have a Prot or +5v as seen in pic below show up when I am converting to PCB however they just disappear?
Thanks for the help!
Werner
How to have a connector stud propagate through to PCB?
Re: How to have a connector stud propagate through to PCB?
The +5V symbol needs to connect to a net.
Re: How to have a connector stud propagate through to PCB?
If PORT1 is bringing +5 to the PCB then put a wire between PORT1 and the +5V.
I would label the PORT1 as Power just to help keep things straight.
I would label the PORT1 as Power just to help keep things straight.