Invalid DRC error?

Report bugs here
Post Reply
Message
Author
Tomg
Expert
Posts: 2028
Joined: 20 Jun 2015, 07:39

Invalid DRC error?

#1 Post by Tomg » 21 Apr 2021, 08:54

Does anyone else see this invalid DRC error with the DipTrace example board named "BGA_autorouter.dip", or is it my setup? I did not change any settings after opening the board file. Even though the gap appears to pass the rule according to the displayed numbers, the DRC still flags it as an error. I have occasionally seen similar DRC "errors" on other designs before. Am I missing something here?...
BGA_autorouter.png
BGA_autorouter.png (22.6 KiB) Viewed 210 times
Tom

Alex
Technical Support
Posts: 3897
Joined: 13 Jun 2010, 23:43

Re: Invalid DRC error?

#2 Post by Alex » 22 Apr 2021, 02:16

I see the same. Probably the reason is very small difference between the rule and measured clearance. We will investigate the issue.

Post Reply