Page 1 of 1


Posted: 26 Mar 2021, 00:51
by KevinA
If you create a header part using the IPC-7153 generator, shrouded or unshrouded, the 3D part looks great but if you try to remove the 3D part it appears you might be able to; 12 pin device, 1.5 hours and I can not get the part to display without a 3D image when place on a PCB, in the pattern editor the image is gone, 16 pin header no problem. There is no checkbox to stop the IPC generator from generating a 3D image. You can click on 3D file in pattern editor and the IPC image disappears from the 3d view but when you place the pattern on a PCB the 3D image is back.
Simple 2.54 pin header...