Pattern Editor DXF import to pads bug

Report bugs here
Post Reply
Message
Author
Tomg
Expert
Posts: 1543
Joined: 20 Jun 2015, 14:39

Pattern Editor DXF import to pads bug

#1 Post by Tomg » 01 Aug 2017, 13:18

The DXF import tool in the Pattern Editor does not properly import a closed figure consisting of one straight line and one elliptical arc when Convert to: is set to "Top Pads". It does, however, properly import the same DXF drawing file when Convert to: is set to "Top Signal". I have included the DXF file used in the illustration shown below...
You do not have the required permissions to view the files attached to this post.
Tom

Serg
Technical Support
Posts: 345
Joined: 09 Jun 2010, 08:12

Re: Pattern Editor DXF import to pads bug

#2 Post by Serg » 02 Aug 2017, 09:28

Thank you for report. We will try to find a cause.

Post Reply