Set Component Properties in Pattern Editor?

Making your own components and patterns, organizing and using libraries.
Post Reply
Message
Author
Benj
Posts: 3
Joined: 15 Apr 2011, 10:35

Set Component Properties in Pattern Editor?

#1 Post by Benj » 15 Apr 2011, 11:07

I have a board with about 100 identical resistors on it. I made my own pattern for it but can't figure out if there is a way to turn off the Main Marking by default, for just this component. All I can do now is to place the resistors on the board and then go into Properties and turn Main Marking off. Is there an easier way to do this? Or a way to edit the font size of the Main Marking for components?

Alex
Technical Support
Posts: 3241
Joined: 14 Jun 2010, 06:43

Re: Set Component Properties in Pattern Editor?

#2 Post by Alex » 18 Apr 2011, 07:57

Hi,

Select all these resistors with box selection or with Ctrl+ key, right click on any of selected resistors and open "Properties" from submenu, go to Marking tab and disable main marking for them.

Post Reply