Hole Confusion

Making your own components and patterns, organizing and using libraries.
Post Reply
Message
Author
tmawson
Posts: 17
Joined: 10 Jan 2011, 20:13

Hole Confusion

#1 Post by tmawson » 04 Feb 2011, 18:53

When placing holes in the pattern editor, there's a hole and an outer. What is the difference between these 2? I think the hole is the actual drilled hole and the outer is the area left free of mask, routing etc. Am I right?
You do not have the required permissions to view the files attached to this post.

Alex
Technical Support
Posts: 3247
Joined: 14 Jun 2010, 06:43

Re: Hole Confusion

#2 Post by Alex » 07 Feb 2011, 07:48

Hi,

Yes, you are right. Outer diameter is area without routing, mask, etc.

tmawson
Posts: 17
Joined: 10 Jan 2011, 20:13

Re: Hole Confusion

#3 Post by tmawson » 07 Feb 2011, 10:15

Thanks

Post Reply