Page 1 of 1

Dual gang stereo potentiometer needed

Posted: 01 Jul 2015, 15:50
by jhorapalok
Do anyone of you have ready made component and pattern of dual gang stereo potentiometer? If you have, then please can you share it? I am badly in need of that.

Re: Dual gang stereo potentiometer needed

Posted: 06 Jul 2015, 12:22
by mtripoli
There are an awful lot of dual gang pot's out there. Which one are you referring to? Manufacturer? Series?

Re: Dual gang stereo potentiometer needed

Posted: 06 Jul 2015, 13:49
by jhorapalok
I want the following type:

Re: Dual gang stereo potentiometer needed

Posted: 06 Jul 2015, 14:32
by dtu2
Got a datasheet?

If not, I have a pot here that looks exactly like this picture. I could measure it and give you the dimensions if that helps you. They wont be as precise as the datasheet but probably close enough for a one-off. But, if this is for a product, I would never try it without the datasheet to make sure you have the right part.

Having said all that, you could make it yourself (it's a very simple thing to do) or I or someone else could make one for you in a couple of minutes.

However, what you would have to do is to determine is the pad and hole size you want.

Also, are you looking for a 3D model as well?

jeff

Re: Dual gang stereo potentiometer needed

Posted: 10 May 2018, 05:29
by jay
can you please provide a 3D model as well ?

Re: Dual gang stereo potentiometer needed

Posted: 11 May 2018, 10:23
by dtu2
Here you go... try this.