Attached PCB generates correctly for gerber, but incorrectly for ODB++.
In the attached picture, you can see the exported gerber is correct. But the ODB++ is not correct.
The PCB file for this is attached. The issue is this: When layer 3 is defined as signal the ODB++ result is correct. When layer 3 is defined as plane, Diptrace handles it correctly, but the generated ODB++ has severe design rule violation.
ODB++ Bug
Re: ODB++ Bug
Thank you for the bug report, we will investigate the problem.
Re: ODB++ Bug
We have fixed the bug under source codes. See attached odb++ archive where the problem has fixed. The next build will include the fix.
- Attachments
-
- pcb.zip
- (48.25 KiB) Downloaded 78 times