ODB++ Bug

Making PCB Layouts, Manual routing, Auto-routing, Copper pouring, Updating from Schematic, Manufacturing Output
Post Reply
Message
Author
matttay
Posts: 59
Joined: 08 Aug 2010, 01:58

ODB++ Bug

#1 Post by matttay » 17 Aug 2022, 12:52

Attached PCB generates correctly for gerber, but incorrectly for ODB++.

In the attached picture, you can see the exported gerber is correct. But the ODB++ is not correct.
Diptrace odb++ Bug.jpg
The PCB file for this is attached. The issue is this: When layer 3 is defined as signal the ODB++ result is correct. When layer 3 is defined as plane, Diptrace handles it correctly, but the generated ODB++ has severe design rule violation.
You do not have the required permissions to view the files attached to this post.

Alex
Technical Support
Posts: 3736
Joined: 14 Jun 2010, 06:43

Re: ODB++ Bug

#2 Post by Alex » 22 Aug 2022, 06:52

Thank you for the bug report, we will investigate the problem.

Alex
Technical Support
Posts: 3736
Joined: 14 Jun 2010, 06:43

Re: ODB++ Bug

#3 Post by Alex » 24 Aug 2022, 06:20

We have fixed the bug under source codes. See attached odb++ archive where the problem has fixed. The next build will include the fix.
You do not have the required permissions to view the files attached to this post.

matttay
Posts: 59
Joined: 08 Aug 2010, 01:58

Re: ODB++ Bug

#4 Post by matttay » 28 Sep 2022, 19:14

Thanks very much, Alex!

Post Reply