Hello DipTrace!
There was a problem with my board routing. The main essence of the problem is that not all tracks are automatically drawn. Despite this, the connection lines are not displayed, which indicates that this track has already been implemented.
How can I make all paths draw instead of straight lines? Perhaps I need to make the tracks themselves thinner for this? Or do you need a large area of the board for the correct wiring of all tracks? Those that were not drawn at all and whose direct connecting lines disappeared, as well as those that were not drawn, but whose connecting lines remained ...
Thanks guru!
Problem with tracks routing (partial)
Problem with tracks routing (partial)
- Attachments
-
- Screenshot_7.png (143.83 KiB) Viewed 119 times
Re: Problem with tracks routing (partial)
Did you route the board with autorouter? Could you share the file for verification?