What happened to Snap to Grid by Origin?

Making PCB Layouts, Manual routing, Auto-routing, Copper pouring, Updating from Schematic, Manufacturing Output
Post Reply
Message
Author
User avatar
MickeyDelp
Posts: 6
Joined: 15 Jun 2010, 05:31
Contact:

What happened to Snap to Grid by Origin?

#1 Post by MickeyDelp » 28 Jul 2020, 07:24

What happened to Snap to Grid by Origin? It now only snaps by pads. Why did that feature go away?

Tomg
Expert
Posts: 2028
Joined: 20 Jun 2015, 07:39

Re: What happened to Snap to Grid by Origin?

#2 Post by Tomg » 28 Jul 2020, 09:12

Look at the selection named "Grid Alignment" just above "Snap to Grid". What's nice about the new version is that it will remember your last setting the next time you use the Snap to Grid function...
stgbo.png
stgbo.png (16.89 KiB) Viewed 149 times
Tom

User avatar
MickeyDelp
Posts: 6
Joined: 15 Jun 2010, 05:31
Contact:

Re: What happened to Snap to Grid by Origin?

#3 Post by MickeyDelp » 28 Jul 2020, 10:45

Thank you Tomg!

Post Reply