One pad, diferent

Making PCB Layouts, Manual routing, Auto-routing, Copper pouring, Updating from Schematic, Manufacturing Output
Post Reply
Message
Author
kivancsi4
Posts: 1
Joined: 25 May 2020, 20:18

One pad, diferent

#1 Post by kivancsi4 » 26 May 2020, 04:28

How can this be achieved?
Pad connects two layers.I would like to be able to specify the size of the PAD for each layer.
You do not have the required permissions to view the files attached to this post.

Alex
Technical Support
Posts: 3197
Joined: 14 Jun 2010, 06:43

Re: One pad, diferent

#2 Post by Alex » 01 Jun 2020, 16:41

Pad rings of through-hole pads are the same on all signal layers in DipTrace. But you can put bigger SMD pad on TH pad if you want to achieve bigger pad ring on certain layer. Connect both pads to the same net to avoid DRC errors in PCB Layout.

Post Reply