autorouting 45 degree components/IC's

Making PCB Layouts, Manual routing, Auto-routing, Copper pouring, Updating from Schematic, Manufacturing Output
Post Reply
Message
Author
Moris
Posts: 68
Joined: 01 Oct 2012, 16:35
Location: Switzerland

autorouting 45 degree components/IC's

#1 Post by Moris » 21 Apr 2020, 06:34

Can the PCB-Editor autoroute components (e.g. IC with 100 Pins) if they are rotated by an angle of 45 degrees?
Thank's for anyones response. :)

Moris
Posts: 68
Joined: 01 Oct 2012, 16:35
Location: Switzerland

Re: autorouting 45 degree components/IC's

#2 Post by Moris » 22 Apr 2020, 10:26

No it can not - found the post again autoroute 45-degree termination to pads.

Post Reply