wiring error in TDR schematic

Drawing Schematics, Hierarchical Design, BOM, Exporting net-lists, etc.
Post Reply
Message
Author
scfaria
Posts: 35
Joined: 20 May 2021, 15:32

wiring error in TDR schematic

#1 Post by scfaria » 22 May 2021, 11:20

Finishing up on this little schematic, which I obtained from an article in ARRL QST magazine, May 2021, page 32, I put in the same circuit into DipTrace and tried to verify the circuit. I get errors on the outputs of U2.1, U2.2, & U2.3: see TDR.png and TDR_err.png. If I disconnect any 2 of the U2s and leave one connected, I get no errors: TDR_err2.png! I sure would like to get rid of the remaining errors when I connect all 3 outputs so I can get on with making a PCB layout!! I sure hope someone knows how to fix this problem as I would really like to get to making a PCB for this project.
Attachments
TDR_err2.PNG
TDR_err2.PNG (6.23 KiB) Viewed 291 times
TDR_err.PNG
TDR_err.PNG (40.45 KiB) Viewed 291 times
TDR.PNG
TDR.PNG (16.15 KiB) Viewed 291 times

Alex
Technical Support
Posts: 3897
Joined: 13 Jun 2010, 23:43

Re: wiring error in TDR schematic

#2 Post by Alex » 23 May 2021, 22:01

You can open "Verification -> Electrical Rule Setup". There it table that defines when errors and warnings are reported. Please notice output to output connection is considered as error (red cell). You can click on the cell to change the rule to either warning or no error.

scfaria
Posts: 35
Joined: 20 May 2021, 15:32

Re: wiring error in TDR schematic

#3 Post by scfaria » 24 May 2021, 06:04

I wish there was a way to mark a post as 'completed' by the original poster. So I can say that you are right on with your solution to my problem. Txs!! syd

Post Reply