This is my very first schematic and I need feedback. I'm going to try to make a PCB out of this schematic. Does what I have done so far seem to be correct? J1, J2 & J3 are supposed to be holes in the final PCB to solder in wires so I hope that is what the schematic is doing. The 5Vdc terminal in the schematic I think should end up being a hole in the final PCB to solder in the 5Vdc from the PS. Not sure about this. This is going to be a very small PCB project, about 2 1/2" x 2 1/2" square PCB and I hope I'm on the right track with this project. So if this endeavor is OK for doing the next phase, making a PCB layout, I'll be going through the next tutorial. Any feedback on this project are well appreciated.
newbie, scf
first schematic attempt
first schematic attempt
- Attachments
-
- TDR.PNG (16.01 KiB) Viewed 210 times