wiring error in TDR schematic
wiring error in TDR schematic
Finishing up on this little schematic, which I obtained from an article in ARRL QST magazine, May 2021, page 32, I put in the same circuit into DipTrace and tried to verify the circuit. I get errors on the outputs of U2.1, U2.2, & U2.3: see TDR.png and TDR_err.png. If I disconnect any 2 of the U2s and leave one connected, I get no errors: TDR_err2.png! I sure would like to get rid of the remaining errors when I connect all 3 outputs so I can get on with making a PCB layout!! I sure hope someone knows how to fix this problem as I would really like to get to making a PCB for this project.
- Attachments
-
- TDR_err2.PNG (6.23 KiB) Viewed 292 times
-
- TDR_err.PNG (40.45 KiB) Viewed 292 times
-
- TDR.PNG (16.15 KiB) Viewed 292 times
Re: wiring error in TDR schematic
You can open "Verification -> Electrical Rule Setup". There it table that defines when errors and warnings are reported. Please notice output to output connection is considered as error (red cell). You can click on the cell to change the rule to either warning or no error.
Re: wiring error in TDR schematic
I wish there was a way to mark a post as 'completed' by the original poster. So I can say that you are right on with your solution to my problem. Txs!! syd