Hello,
When there is no load, the PWM HO and LO outputs will appear PWM periodically and briefly, accompanied by a whistle of the inductor. At this time, the input voltage will also have a downward peak value, and the output voltage will be unstable.
When loaded, the input voltage is no longer a constant level, but a regular sawtooth wave, and only when the input voltage waveform is lower than a certain value, the HO\LO pin will generate PWM, otherwise, it will not generate PWM, at this time the inductance whistle, the output voltage is a sawtooth wave in the opposite direction to the input voltage.
Here is the datasheet link: https://www.utmel.com/productdetail/tex ... pb-7802861
Hope for helping!
Good listening!
An Unusual Situation From LM5122
An Unusual Situation From LM5122
Continued to searching something new in electronic:
https://www.utmel.com/components/ds3231 ... uit?id=389
https://www.utmel.com/components/ds3231 ... uit?id=389