I've been doing simple designs with Diptrace for a few years and getting moderately comfortable and gone through PCB fabrication quite successfully.
Just noticed an issue with my latest board, where the placed component in PCB layout is different from what I see in the component editor. It's a MOSFET that I imported using Library Loader and the Component Editor view matches the datasheet.
But, for reasons unknown, when I place the component into my design (even a blank new one), the drain/source pins get swapped:
What would cause this?
Placed component is different from library
Re: Placed component is different from library
Please upload the library and I will verify it.