License info isn't being stored

For general questions regarding the software and for all questions that do not fit in any of the threads above.
Post Reply
Message
Author
artemen
Posts: 2
Joined: 08 Feb 2016, 03:37

License info isn't being stored

#1 Post by artemen » 24 Apr 2019, 02:42

HI, i've been using 3.3 for a while now, had to clean my PC registry (unrelated issue), used register cleaner tool called CCCleaner and didn't make a backup of the regkeys. License key was erased and for some reason license info isn't being stored anymore- I have to enter it every time I open either a schematic on pcb file.
I've tried complete uninstall, than installed 3.3 again with no improvement. i assume I've messed up windows registry, please advise what can be done(apart from reinstalling windows), thanks!

Alex
Technical Support
Posts: 3170
Joined: 14 Jun 2010, 06:43

Re: License info isn't being stored

#2 Post by Alex » 25 Apr 2019, 08:49

Registration key is not memorized if you run programs as regular user. Run either Schematic or PCB Layout as administrator, enter registration data and information will be memorized. Next time you can run programs as regular user.

Post Reply