Irregular angle for trace placement

"How-to" questions from new engineers and designers. Please ask and respond here.
Post Reply
Message
Author
nn1024
Posts: 3
Joined: 29 Apr 2016, 10:11

Irregular angle for trace placement

#1 Post by nn1024 » 14 Dec 2021, 22:28

Hi all,
I have a PCB where a component (connector) is placed at an irregular angle (say 30 degrees), and I would like to make the traces reach the component at that angle, instead of 90deg or 45deg.
Is this possible? If yes, then how do I set the angle?

Thanks in advance,
Noam

Tomg
Expert
Posts: 2028
Joined: 20 Jun 2015, 07:39

Re: Irregular angle for trace placement

#2 Post by Tomg » 15 Dec 2021, 02:08

Yes.
You will have to eyeball it, but using the "Free Line" routing mode should get you close to what you want...
fl.png
fl.png (9.7 KiB) Viewed 1187 times
Tom

Post Reply