Design Rule Check Problems

"How-to" questions from new engineers and designers. Please ask and respond here.
Post Reply
Message
Author
donjlutz
Posts: 1
Joined: 16 Oct 2020, 07:00

Design Rule Check Problems

#1 Post by donjlutz » 16 Oct 2020, 07:08

When I run DRC on my board, everywhere that I have a thermal reports an error (or two). I can clear the error(s) by removing the thermal. I have had this problem in the past.

What is the source of this problem and how can I correct it? I've attached a screenshot.
Attachments
Capture.JPG
Capture.JPG (85.53 KiB) Viewed 189 times

Serg
Technical Support
Posts: 519
Joined: 09 Jun 2010, 01:12

Re: Design Rule Check Problems

#2 Post by Serg » 18 Oct 2020, 23:15

Check, that these pads/via aren't placed over other via which coordinates are coincide.
If the problem will continue, please send the design file(.dip) to our technical support:
support at diptrace.com

Post Reply