When I run DRC on my board, everywhere that I have a thermal reports an error (or two). I can clear the error(s) by removing the thermal. I have had this problem in the past.
What is the source of this problem and how can I correct it? I've attached a screenshot.
Design Rule Check Problems
Design Rule Check Problems
- Attachments
-
- Capture.JPG (85.53 KiB) Viewed 190 times
Re: Design Rule Check Problems
Check, that these pads/via aren't placed over other via which coordinates are coincide.
If the problem will continue, please send the design file(.dip) to our technical support:
support at diptrace.com
If the problem will continue, please send the design file(.dip) to our technical support:
support at diptrace.com