How to divide the scheme on two pcb plates?

"How-to" questions from new engineers and designers. Please ask and respond here.
Post Reply
Message
Author
AlexTitov
Posts: 1
Joined: 08 Jun 2017, 08:41

How to divide the scheme on two pcb plates?

#1 Post by AlexTitov » 08 Jun 2017, 08:59

My scheme is a controller with high-load transistors. I would like put the control part on the one PCB, and the power part on another PCB. What is the best way to do that?
I tried to put my scheme onto two sheets in Schematics and used bus connectors between sheets. But all these go onto single PCB anyway.

I realize that I can divide the scheme into two separate projects. But I hope to export my scheme into some simulator some later so it should be single complete scheme for that.

Love life
Posts: 8
Joined: 01 Apr 2017, 02:09

Re: How to divide the scheme on two pcb plates?

#2 Post by Love life » 23 Aug 2017, 05:37

Then you can design two schematics. One is the control module circuit, one is the power module circuit.
Then use the cable link.

Post Reply