You can export your board to PDF: "File -> Export -> PDF" in PCB Layout.

It looks like SMD pads were tented. You can right click on a SMD pad in PCB Layout, open "Mask/Paste Settings" from submenu and verify the settings. Specifically, check top solder mask and bottom solder mask. If they were tented, change to "Common State" (that is open by default)...

Thank you for the report. Could you please send the ODB++ file to DipTrace support or upload on the forum.

Thank you for the report, we have added the issue to bug tracker and will investigate it. It looks like a custom problem. DRC just shows the warning but it can't stop PCB order if you agree to send the order with DRC issues (press No on the corresponding pop up window). It couldn't be browser issue ...

Thank you for the suggestion, we will consider the option of multicolored PCB fabrication.

Sure, there is DRC in DipTrace PCB Layout. First open "Verification -> Design Rules" to see and edit design rules. Then run "Verification -> Check Design Rules" to perform the verification. In result you will see the list of errors, red circles on the design area showing the erro...

Similar to saving components from schematic to component library, you can save patterns from PCB Layout to pattern library. Just right click on a pattern in PCB Layout, select "Save to Library -> Save to File" from submenu, enter library name, hint and group and save the file.

1. Please open "Verification -> Electrical Rule Setup". There is Power Pins for SC" (short circuit) in the bottom right corner. By default, they are V* and GND*. So any pin which name starts from V is considered as power pin. But you can edit the field and change V* to something more ...

Thank you for the request. We will investigate how AI might be integrated into DipTrace.

Are there route keepout or board cutout around the connector? How about design rules and net classes? I ask them because interactive router checks rules on fly and doesn't allow to violate them. You can press "I" hot key during manual routing to disable interactive mode and see if there is...