Author Message
 Post subject: 2.54 mm through-hole male post headers
PostPosted: 05 Oct 2017, 20:35 
Offline

Joined: 05 Oct 2017, 12:05
Posts: 4
I'm new to DipTrace Schematic Capture, so the following are beginner's questions.

1. I need help finding 2.54 mm (0.1 inch) post-to-post through-hole vertical mount male post headers. I have been looking in "Con Headers". What is the correct part number series?

2. I am assuming that "Con Headers" means male components, how are the female side 2.54 mm socket series enumerated?

3. Also, is there an index that describes the components by the numbers given?

4. And, is there a library that shows the 3D view of the enumerated parts?

Thanks for your assistance.
Bob


Top
 Profile  
 
 Post subject: Re: 2.54 mm through-hole male post headers
PostPosted: 06 Oct 2017, 01:58 
Offline

Joined: 28 Sep 2017, 08:53
Posts: 3
Hi you can find some 3d models at grabcad , so https://grabcad.com/library/header-6p-f ... tch-2-54-1 is female header 2.54


Top
 Profile  
 
 Post subject: Re: 2.54 mm through-hole male post headers
PostPosted: 06 Oct 2017, 06:18 
Offline

Joined: 18 Dec 2015, 15:35
Posts: 162
With Pattern Editor click on Con Headers:
Type Rows Pins T and TH=Through Hole Pitch
HDR - 1 x 2 T 2.54
HDR-2X1T/2x2/ Two row one pin (two pins total) 2mm pitch

HDR means MALE pins
HDRF is the female receptacle

HDRF-1X2T/1.27 is a female 1 row 2 pin 1.27mm pitch receptacle

If you have a question what it is click the Datasheet the PDF will open

My personal favorite one: HDRF-2X36S/2.54 (S and SZ are Surface Mount)
A 2X36 72 pin surface mount female header that no one stocks... I found them in China Match STM Nucleo boards.

Spend some time in the library looking at what you have before you start building your own or downloading.

You can check the 3D model for each part by clicking , 3D Model... button

Another good place to spend some time is the Con Jacks and Memory Cards - They have SD sockets from everyone.


Top
 Profile  
 
 Post subject: Re: 2.54 mm through-hole male post headers
PostPosted: 06 Oct 2017, 16:20 
Offline

Joined: 05 Oct 2017, 12:05
Posts: 4
Hi Volkan and KevinA,

Thanks for your help. I've got it!

Thanks again, Bob


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group