Pattern Editor DXF import to pads bug

Report bugs here
Post Reply
Message
Author
Tomg
Expert
Posts: 2028
Joined: 20 Jun 2015, 07:39

Pattern Editor DXF import to pads bug

#1 Post by Tomg » 01 Aug 2017, 06:18

The DXF import tool in the Pattern Editor does not properly import a closed figure consisting of one straight line and one elliptical arc when Convert to: is set to "Top Pads". It does, however, properly import the same DXF drawing file when Convert to: is set to "Top Signal". I have included the DXF file used in the illustration shown below...
Attachments
line_and_elliptical_arc.zip
(7.61 KiB) Downloaded 34 times
all.gif
all.gif (15.8 KiB) Viewed 148 times
Tom

Serg
Technical Support
Posts: 519
Joined: 09 Jun 2010, 01:12

Re: Pattern Editor DXF import to pads bug

#2 Post by Serg » 02 Aug 2017, 02:28

Thank you for report. We will try to find a cause.

Post Reply