Author Message
 Post subject: Pattern Editor DXF import to pads bug
PostPosted: 01 Aug 2017, 13:18 
Offline
Expert

Joined: 20 Jun 2015, 14:39
Posts: 939
The DXF import tool in the Pattern Editor does not properly import a closed figure consisting of one straight line and one elliptical arc when Convert to: is set to "Top Pads". It does, however, properly import the same DXF drawing file when Convert to: is set to "Top Signal". I have included the DXF file used in the illustration shown below...


You do not have the required permissions to view the files attached to this post.

_________________
Tom


Top
 Profile  
 
 Post subject: Re: Pattern Editor DXF import to pads bug
PostPosted: 02 Aug 2017, 09:28 
Offline
Technical Support

Joined: 09 Jun 2010, 08:12
Posts: 208
Thank you for report. We will try to find a cause.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group