Author Message
 Post subject: 3D viewer not showing components, only the pcb
PostPosted: 12 Jul 2017, 05:31 
Offline

Joined: 11 Mar 2017, 00:58
Posts: 1
After upgrading to V3.1.0.1 (64bit) on a W10 PC, I can't get 3D modelling to work again.

Eventually, I ended up deleting the models3d directory and downloaded and installed the 3D libraries again.
I made sure that they installed in C:\Program Files\DipTrace, where the rest of the software is located.
My path to the models is correct in the Pattern and Model Search dialog box.

When I invoke 3D Visualization, I only get the model of an LED showing, but nothing else.
When I remove the tick for components, and redraw, the PCB shows correctly. Obviously without components.

When I add the tick for components and select Redraw, there is the normal activity showing, then the display blanks for a moment, and I'm back to the single model of an LED.

When I go through the model selection process for my components, all the component models load, but even when I add them to the project, the result is the same.

What am I doing wrong?

Tks!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group