Autoroute

Making PCB Layouts, Manual routing, Auto-routing, Copper pouring, Updating from Schematic, Manufacturing Output
Post Reply
Message
Author
happytriger2014
Posts: 2
Joined: 12 Apr 2017, 17:34

Autoroute

#1 Post by happytriger2014 » 17 Apr 2017, 04:44

Hi,
I'm having a problem after Autoroute I get a line crossing a pad which cause short circuit and this is after verification, please have a look at the image link below,
The part circled in purple:
Image

does this have anything to do with the Autoroute setup? if so how should I set it?

Alex
Technical Support
Posts: 3897
Joined: 13 Jun 2010, 23:43

Re: Autoroute

#2 Post by Alex » 18 Apr 2017, 02:12

Could you upload board file on the forum or send to DipTrace support?

happytriger2014
Posts: 2
Joined: 12 Apr 2017, 17:34

Re: Autoroute

#3 Post by happytriger2014 » 20 Apr 2017, 23:19

Hi Alex,
I have replied twice and somehow the email didn't reach you....I received this: mailer-daemon@googlemail.com, will send it again to support.

Alex
Technical Support
Posts: 3897
Joined: 13 Jun 2010, 23:43

Re: Autoroute

#4 Post by Alex » 24 Apr 2017, 01:02

Our support mail account was full. We cleared it so you can send files to support.

Post Reply