Knowing which components are using which size holes?
Knowing which components are using which size holes?
I mill my own PCBs. Often when I want to export the drill file I want to make adjustments on holes. Perhaps making two for the near size the same size to avoid tool change. It is a pain to have to look at the pad properties for each of the components. Is there a way to get a table of each component's pad hole size or at least search for the size? Something easier than looking at pad properties.
Re: Knowing which components are using which size holes?
Try the following: File->Layout Information->Holes(...)->Show on Board. You can select hole by size and see them on design area.
Re: Knowing which components are using which size holes?
Excellent! Thanks!
Why is there a difference between .035" holes and .035" holes? All properties seem to be the same but I have 2 sets of entries with the same size.
Why is there a difference between .035" holes and .035" holes? All properties seem to be the same but I have 2 sets of entries with the same size.
-
- Posts: 188
- Joined: 09 Jan 2015, 19:00
- Location: Anaheim, CA 92806
- Contact:
Re: Knowing which components are using which size holes?
What difference you found between .035" holes and .035" holes.spinnaker wrote:Excellent! Thanks!
Why is there a difference between .035" holes and .035" holes? All properties seem to be the same but I have 2 sets of entries with the same size.