Author Message
 Post subject: Circular Trace Connections
PostPosted: 21 Aug 2016, 11:09 
Offline

Joined: 20 Apr 2016, 10:10
Posts: 5
Hi,
for some reason I have to connect a net to itself / building a circular trace connection.
The problem is, that for example if I try to make this:
Attachment:
1.png

DipTrace removes the redundant part so I get this:
Attachment:
2.png


So how I can prevent this behavior from DipTrace ?


You do not have the required permissions to view the files attached to this post.


Top
 Profile  
 
 Post subject: Re: Circular Trace Connections
PostPosted: 21 Aug 2016, 11:56 
Offline
Expert

Joined: 20 Jun 2015, 14:39
Posts: 939
1) In the PCB Layout editor, go to the Main Menu, click on Route and then select Route Setup... in the drop-down menu.
2) In the Route Setup dialog window, select the Settings tab, disable Remove Loops (bow tie effect) and click on OK.

Note: Terminate the loop using the [Enter] key.

_________________
Tom


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group