---------------------------------------------------------------------------------------------
Setup I
Display Mode: Contrast
Active Layer: Top
Selection: Drag a selection box around all four components.
Result I (see figure 1)
PASS: U1 (on active layer) is selected.
PASS: U2 (on active layer) is selected.
FAIL: U3 (not on active layer) is selected.
FAIL: U4 (not on active layer) is selected.
---------------------------------------------------------------------------------------------
Setup II
Display Mode: Contrast
Active Layer: Top
Selection: Hold down Ctrl key and left-click once on each component (not pin).
Result II (see figure 2)
PASS: U1 (on active layer) is selected.
PASS: U2 (on active layer) is selected.
PASS: U3 (not on active layer) is not selected.
PASS: U4 (not on active layer) is not selected.
---------------------------------------------------------------------------------------------
Setup III
Display Mode: Contrast
Active Layer: Top
Selection: Hold down Ctrl key and left-click once on only one pin of each component.
Result III (see figure 3)
PASS: U1 (on active layer) is selected.
PASS: U2 (on active layer) is selected.
PASS: U3 (not on active layer) is not selected.
FAIL: U4 (not on active layer) is selected.
---------------------------------------------------------------------------------------------
PCB Layout - Contrast mode selection bug
Re: PCB Layout - Contrast mode selection bug
Thank you for the report. We will investigate different methods of selection in contrast mode.