Author Message
 Post subject: ESP8266 development board
PostPosted: 07 Jul 2016, 11:01 
Offline

Joined: 01 Jul 2016, 06:03
Posts: 3
I have some ESP8266 ESP-07 modules. I got some PCB's off ebay to convert them to a standard 0.1" pin spacing but they were quite wide and would not fit onto a standard breadboard prototyping strip. So I decided as my first project to make my own.
Attachment:
ESP-07 Dev Rev 3.GIF

Each GPIO pin can be switched using a set of jumpers to be either connected to the strip which is 3V logic levels or via 3V to 5V bi-directional logic level converters onto the other strip.
GPIO0 if unused would normally be switched to the 3V side to avoid it being interfered with by the level converters. It has an internal 10K pullup resistor for normal operation and a jumper which can be used to pull it to ground for programming.
GPIO2 is normally high so if not being used for anything this should be switched to the logic level converter side where there is a 10K pullup resistor.
GPIO15 is normally connected to ground. I have added a 10K resistor to ground on the 3V side so that this can be selected and no additional wiring is required.
The ESP8266 can be either powered by 3.3V into the supply pin on the header or alternatively power can be supplied via the DC input jack or adjacent header which then goes to a 3.3V and 5V regulator. Both regulators have jumpers to connect them to the internal 3.3V and 5V voltage rails so that for example this can be used to power an Arduino.

Any comments or suggestions are most welcome as this is the first PCB designed for quite a long time and already at the 3rd revision. I haven't sent it off to get made yet as I am waiting for the DC jacks to arrive so that I can confirm the pin spacing is correct.


You do not have the required permissions to view the files attached to this post.


Top
 Profile  
 
 Post subject: Re: ESP8266 development board
PostPosted: 12 Aug 2016, 07:40 
Offline

Joined: 10 Jan 2015, 02:00
Posts: 188
Location: Anaheim, CA 92806
I like your ESP8266 development board design.
Does it useful for my Internet-connected project? I think it is capable of having WiFi-enabled microcontroller.

_________________
PCB Manufacturing


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group