I don't know if this is a bug or if there is some setting that I've missed. I'm running Beta 3.0. I'm trying to fit the entire BOM on one page. If I open the schematic in 2.4.02 I can easily get 52 line items on one page with room to spare, but on Beta 3.0 I can only get 28 line items per page, even though the bottom half of the page is blank. As far as I can tell all the BOM settings are the same between both versions.
Also, I noticed that on both versions if I set a column width to be greater than 2.5 inches on the "Create Bill Of materials" menu, the column width remains at 2.5 inches. If I open the BOM once it is created I can then adjust the column width wider than 2.5 inches, but since the limited column width caused some of the items to roll over to the next page, it doesn't help much.
Am I missing something?
Thanks!
-Rick
Number of lines on BOM
Re: Number of lines on BOM
Hi Rick,
We didn't change BOM export in the beta version at all. It works the same as in version 2.4. Could you send schematic file to support at diptrace dot com.
We didn't change BOM export in the beta version at all. It works the same as in version 2.4. Could you send schematic file to support at diptrace dot com.
Re: Number of lines on BOM
This anomaly is corrected as of version 3.0.0.2.
Thanks, guys!
-Rick
Thanks, guys!
-Rick