DipTrace Forum
http://www.diptrace.com/forum/

Pattern Editor DXF import to pads bug
http://www.diptrace.com/forum/viewtopic.php?f=9&t=11724
Page 1 of 1

Author:  Tomg [ 01 Aug 2017, 13:18 ]
Post subject:  Pattern Editor DXF import to pads bug

The DXF import tool in the Pattern Editor does not properly import a closed figure consisting of one straight line and one elliptical arc when Convert to: is set to "Top Pads". It does, however, properly import the same DXF drawing file when Convert to: is set to "Top Signal". I have included the DXF file used in the illustration shown below...

Author:  Serg [ 02 Aug 2017, 09:28 ]
Post subject:  Re: Pattern Editor DXF import to pads bug

Thank you for report. We will try to find a cause.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/