Pattern Editor DXF import to pads bug
Pattern Editor DXF import to pads bug
The DXF import tool in the Pattern Editor does not properly import a closed figure consisting of one straight line and one elliptical arc when Convert to: is set to "Top Pads". It does, however, properly import the same DXF drawing file when Convert to: is set to "Top Signal". I have included the DXF file used in the illustration shown below...
- Attachments
-
- line_and_elliptical_arc.zip
- (7.61 KiB) Downloaded 34 times
-
- all.gif (15.8 KiB) Viewed 149 times
Tom
Re: Pattern Editor DXF import to pads bug
Thank you for report. We will try to find a cause.