Autorouter Bug - Pattern Editor Route Keepouts [fixed v3.0.]
Autorouter Bug - Pattern Editor Route Keepouts [fixed v3.0.]
Route Keepouts created in the Pattern Editor on the Top layer (same side as component) do not prevent the Autorouter from routing traces to the protected pads after the component has been changed to the Bottom side in the PCB Editor. This happens even though the component's (R2) Route Keepouts have followed R2 to the Bottom side. The traces still get routed on the Bottom side instead of the Top side where Route Keepouts for R2 no longer exist. A component without any Route Keepouts (R4) was placed on the Top side and changed to the Bottom side. Then Route Keepouts were added to R4 (in the PCB Editor) on the Bottom side and the Autorouter routed to R4's Top pads as expected. The example PCB file (ABres.dip) has been attached...
- Attachments
-
- ABres.dip
- (9.84 KiB) Downloaded 23 times
-
- ABres.jpg (300.64 KiB) Viewed 147 times
Last edited by Tomg on 13 Apr 2016, 01:59, edited 1 time in total.
Tom
Re: Autorouter Bug - Pattern Editor Route Keepouts
Thank you for the report. I confirm the bug. We will fix it for the next version.