DipTrace Forum
http://www.diptrace.com/forum/

Varying Pad Stacks
http://www.diptrace.com/forum/viewtopic.php?f=8&t=9834
Page 1 of 1

Author:  grieblm [ 14 May 2014, 05:43 ]
Post subject:  Varying Pad Stacks

I'm trying to create a footprint pad stack that has different pad shapes on different layers.
Most other PCB tools can do this.
Can this feature be added to DipTrace?

Author:  mtsoule [ 23 Jul 2017, 12:57 ]
Post subject:  Re: Varying Pad Stacks

+1 on this, I have a through hole component, and I need a larger pad on the solder side and a smaller one on the component side.

Author:  KevinA [ 23 Jul 2017, 17:20 ]
Post subject:  Re: Varying Pad Stacks

I just tried to create a device with square pads on top, round on bottom and a hole in the center. It imported ok to the pattern editor but the bottom pads got their own set of numbers, when I used that pattern on the PCB editor all the pads ended up being the same as the top pad...

Pad stacks would be a good add to DT but when you look at a program that supports pad stacks it get complicated $$.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/