Author Message
 Post subject: Schematic custom sheet templates
PostPosted: 26 Aug 2010, 12:19 
Offline

Joined: 29 Jun 2010, 13:28
Posts: 11
I just fought with this (because I haven't done a new schematic in a few weeks). I have created a custom template for my company so all the title blocks are uniform. So when I go into File -> Titles and Sheet Setup... the first Sheet Template in the top dropdown list is None would be nice if it was my custom XYZ template by default. Ok now the biggie ... if I select the XYZ template it is not populated through out the Title Blocks tabs so one must then go to, in my case, Title Blocks/BottomRight and select XYZ again! This is none intuitive if I select my custom template at the start of this dialog it should percolate throughout the dialog selections.

-- 26 Aug 2010, 10:23 --

Oh, and one other thing. The Close button should be the only "Accept changes" button in the dialog. Currently both the Close button and the Red X button act as "Accept changes". The exit button (Red X) should act as an exit without making any changes (a cancel button)


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group