Author Message
 Post subject: PCB Layout - stitching vias
PostPosted: 23 Nov 2016, 07:07 
Offline
Expert

Joined: 20 Jun 2015, 14:39
Posts: 945
In the Properties panel on the right side of the PCB Layout editor, add a Default Net: selection for Static Vias. Once a Default Net has been assigned, any subsequent placement of a Static Via will result in it being automatically connected to that pre-selected Net. Upon closing the Static Via tool, if the [X] Remember last selection option is enabled, the Default Net will be automatically set to the last selected Net the next time the tool is used. If the [ ] Remember last selection option is disabled, the Default Net will be automatically set to "None" the next time the tool is used. This will speed up the process of "stitching vias" on the PCB.


You do not have the required permissions to view the files attached to this post.

_________________
Tom


Top
 Profile  
 
 Post subject: Re: PCB Layout - stitching vias
PostPosted: 23 Nov 2016, 17:00 
Offline
Expert
User avatar

Joined: 22 Aug 2011, 05:29
Posts: 98
Location: Vilnius, Lithuania
That and shift-add to net.

_________________
My rhombicosidodecahedron is bigger than yours.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 7 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group