Author Message
 Post subject: Zoom Fit Component 3D Models and Align Pads
PostPosted: 26 May 2016, 15:49 
Offline

Joined: 20 Apr 2013, 15:41
Posts: 6
I recently had a 3D model that had some whacky origin problem and it's very far away from the origin. It even took me awhile to figure out where it was in the 3D space. Once I found it it was very difficult to know if I should be adjusting X, Y, or Z because I couldn't see where the origin was. If I could "zoom fit" the 3D model, I could find it easily and then I would want to select a surface on the model and align it with one of the pads. This way I would at least be able to get it in the right spot and make adjustments from there. See attached for the issue. Thanks!


You do not have the required permissions to view the files attached to this post.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 5 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group