Hi to all!! I would like to see in Diptrace:

• Possibility to auto-convert value if inserted in a unit different from the selected one: if I write number without unit, program consider the default one, but if inches are selected and I write 100mil (for example), program convert in 0.1inch.
• Auto neck-down of traces.

Thank you for your attention!
Bye!

Stefano

P.S. Sorry for my bad english!

Hello Stefano,

Thank you for the suggestions.
Notice, auto neck-down feature works if you route wide trace to/from a thin pad. Neck-down wide trace between two pads is not available.