DipTrace Forum
http://www.diptrace.com/forum/

New Library issue
http://www.diptrace.com/forum/viewtopic.php?f=5&t=11770
Page 1 of 1

Author:  KevinA [ 26 Aug 2017, 12:46 ]
Post subject:  New Library issue

In PCB editor I want to save headers pins as a pattern, I select the pins for the header, click Group into Component (Component? It is a pattern) and then I select that new pattern and click Save to Library which says Save to File and here is my problem:
I can't save a pattern to a library, I have to create new libraries for each and every pattern! When I'm done I can open each library and move the pattern to my main library but that's a lot of work, why can't I save a pattern to an existing library?

Author:  Tomg [ 27 Aug 2017, 06:45 ]
Post subject:  Re: New Library issue

After grouping into a component you must select the User Patterns library group in the Place Component panel (left side of screen) and then select/highlight one of the libraries in its list as the destination library before attempting to save the newly-created component's pattern. See this thread for more detail - http://www.diptrace.com/forum/viewtopic.php?f=5&t=11503.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/