DipTrace Forum
http://www.diptrace.com/forum/

Colors in Component Editor?
http://www.diptrace.com/forum/viewtopic.php?f=5&t=11760
Page 1 of 1

Author:  steve65 [ 19 Aug 2017, 15:33 ]
Post subject:  Colors in Component Editor?

The Component Editor provides lines, arcs, rectangles, filled rectangles, etc. for use in making a component. When placed in the design field, these items are blue in color. Is there a way to change their color?

Steve

Author:  Tomg [ 19 Aug 2017, 16:25 ]
Post subject:  Re: Colors in Component Editor?

Only globally for the drawing figure outline/solid fill, and this has to be set up in the Schematic Editor (View > Colors... > [Program Colors] tab > Part Graphics). You can add a separate "transparent" fill color (if the right color is selected) in the Schematic Editor, but it's a tedious job to do this for all of the desired components as you must replicate the component shape. A much better solution would be to give the Component Editor the ability to locally change outline colors and add different transparent fills for individual components so a lot of time doesn't have to be wasted creating fills in the Schematic Editor. Here is an older post with just such a request - http://www.diptrace.com/forum/viewtopic.php?f=8&t=10493&p=18207.

Author:  steve65 [ 19 Aug 2017, 17:04 ]
Post subject:  Re: Colors in Component Editor?

Thanks Tom. I had searched a good bit for a way to change colors in Component Editor but no joy. I was fearful this would be the case :(

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/