DipTrace Forum
http://www.diptrace.com/forum/

Pattern for surface mount shunt
http://www.diptrace.com/forum/viewtopic.php?f=5&t=11612
Page 1 of 1

Author:  rovman [ 02 Jun 2017, 13:50 ]
Post subject:  Pattern for surface mount shunt

I made a pattern for a surface mount current shunt. It has a large square pad at each end with a thin rectangular pad overlayed on each for the current sensing connection. The problem is that DipTrace complains that the pads have zero space between them. I have had similar problems with other components such as mini fuse holders that have two pins connected together at each end requiring a rectangular pad with two holes (2 pins connected together).
Any suggestions on dealing with such components?
The shunt is DigiKey YAG4103CT-ND, 0.002 ohm, 5W (Yageo PU5931FKMT50R002L)
The fuse holder is DigiKey 36-3568-ND

Author:  Tomg [ 02 Jun 2017, 14:34 ]
Post subject:  Re: Pattern for surface mount shunt

You may be over-thinking the solution. (Or am I under-thinking it?) I believe all you need is a two-pad pattern. How you handle the schematic symbol is another story, of course. For the fuse holder, try a four-pad pattern.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/