Author Message
 Post subject: Irregularly pad
PostPosted: 19 Oct 2015, 06:18 
Offline

Joined: 19 Oct 2015, 06:13
Posts: 1
Hi
This is my first attempt to make a footprint, so maby I am missing something obvious.

One of the pads is a rectangle with a hole. The hole should be adjusted towards the right side. (not placed in the middle of the pad.)

How do I achive this?

//lg


Top
 Profile  
 
 Post subject: Re: Irregularly pad
PostPosted: 05 Nov 2015, 09:38 
Offline

Joined: 08 Oct 2015, 08:06
Posts: 9
Location: San Diego, CA
To add a pad to a project that will share a common edge with an existing pad, you must use the same line as the common edge. To do this, you must edit the original pad to access the sketch lines.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group