It's been a long time since I got this frustrated!
I arranged couple of parts together, and I thought it would be a good idea to group those, so I can move all of them together around.
So, I grouped a couple of parts, then I made other modifications in other parts of the PCB...
Later I found out then I made a mistake in the group, and then I did ungroup, but all the parts broke apart!!! all the lines I can move them individually, the pads I can break them apart...
When you group the components, then you ungroup, would you not expect it to be the way it was before? As components? not as individual lines, and pads, etc...
See attached, left is when it's grouped, and right side it's ungrouped, and all components are broken, I can't click on a component anymore!!
I have to start the whole PCB from scratch, because I can't properly ungroup!!
You do not have the required permissions to view the files attached to this post.